PART #:SP-RAN-147-O
Product Description
This cold pipe is designed for your Ford Ranger & Mazda bt50 3.2L turbo with HDi Ford Ranger PX1,PX2 & Mazda bt50 Intercooler Kit or other brand of intercooler kit
It is the perfect upgrade for your standard soft rubber hose.!!!
-This hose features Silicone nomex Oil and heat resistant layer!
-Original cold pipe replacement design, easy to install
-Awesome improvement in throttle response through out the rpm range
Supplied with quality stainless hose clamps
Easy to install,direct bolt on itemIt may take 15-30mins to remove the factory hose depending on your skill level
HDi Ford PX1,2 Ranger/Mazda Bt50 Turbo Intercooler cold pipe 3.2L oil resistance
Tech Specs
The HDi Ford Ranger/Mazda Bt50 GT2 benefit as below:
Improved low end throttle response (refer dyno)
Minimal pressure drop despite large intercooler sizing (thanks to HDi GT2 technology)
Increased torque range at low end (refer dyno)
Reduction of both inlet temperatures
less engine running temperatures
Increased performance
Better reliability and consistency
Increase power throughout entire RPM range (not only focusing on the PEAK)
Improve fuel efficiency*
Best value for money
Performance guaranteed!
The kit comes with HDi reinforced Silicon hose to replace the standard Rubber hose which prompt to expand and split.
Full stainless steel screws and brackets the best durability against water and salt corrosion.
The special design allowing enough area for aftermarket 4wd winch to be installed
It also allows good air flow to the radiator!
*The reduced inlet restriction and inlet temperature provides higher density of oxygen for better combustion with the same amount of fuel. Hence, increase mileage!